FLOORING REFINISH & REUSE

    Find your uses and the nails you want to remove below.  Then follow the link to select the right model

     Drive nails FROM THE POINT out of :

    Drive nails FROM THE HEAD:

      Use the SAME denailer for the HEADS & THE POINTS of different nails....
    • flooring with nails,cleats, or staples
    • trim - wood, particle board & composites
      • to countersink nails 1/8" (3 mm) or 3/8" (9.5 mm) deep to prepare for refinishing
      • to set raised nails in decks, framing, & subfloors
      • combining the uses
      1. From the selections below note the tool needed for each range of nails you have.
      2. Determine the most common or most urgent size to remove.  
      3. Click the tool for that range of nails.
      4. For the other ranges of nails, determine if you will need additional tools or if having additional driver/nose sets* on hand will work better.  Select those pieces after putting the first tool in your cart. In addition to buying tools, you can buy up to 3 additional driver/nose sets and 1 set of recommended repair parts for each tool without paying for additional shipping.
      * The only differences between the V20 denailer models is the diameter of the driver and its matched nose.  We call that pair a "driver/nose set".  They are designated by the letters DN, as in DN40 when sold separately from a tool.  The number attached to V20 indicates the driver/nose set in the body; for instance V20-40 indicates a DN40 driver/nose set is in the body.  Each driver/nose set can be removed from a tool body and replaced with one of the same or a different size in 3 to 5 minutes (see silent video).  
        

           

          FIND YOUR FASTENER BELOW, THEN SELECT THE TOOL BELOW IT:

              • Where all nails are 16d box nails or smaller (0.135", 9/64" or 3.76 mm in diameter). These nails will be less than 3 1/2" (90 mm) long.
              • including flooring nails and cleats
              • For flooring staples with a 3/16" wide crown (0.1875" or 4.8 mm)
              • All nails are between sizes 16d box to 30d common (0.135"-0.207", 9/64"-13/64", or             3.75-5.26 mm diameter).  These nails will be approximately 3 1/2-4 1/2" (90 - 115 mm) long.
              • OR  a very wide range of nail sizes between 6d box to 30d common (0.099"-0.207, 3/32"-13/64", or 2.51-5.26 mm diameter)
              • For flooring staples with 7/16" (0.4375" or 11.1 mm) wide crown

                  FIND THE RANGE OF HEAD DIAMETER THAT FITS, THEN SELECT THE TOOL BELOW IT.

                       

                       

                       

                       

                       

                        FIND YOUR COMBINATION BELOW:
                        • For a very wide range of nail sizes between 6d box to 30d common (0.099"-0.207, 3/32"-13/64", or 2.51-5.26 mm diameter) AND occasionally drive heads <= 1/4" diameter (0.250" or 6.35 mm)  
                        •  all nails are 16d box nails or smaller (0.148", 9/64" or 3.76 mm in diameter) AND occasionally drive or set finish nails.

                          Still have questions? 

                        Call 303-554-8557or email admin@reconnx.com

                              Liquid error (layout/theme line 405): Could not find asset snippets/judgeme_html_miracle.liquid