| Hit nails on THE POINT to clean or dismantle the following.... |
- Clean pre-cast & cast-in-place & flying forms
- Remove nails from temporary bracing
FIND YOUR FASTENER:
- all nails are 16d box nails or smaller (0.148", 9/64" or 3.76 mm in diameter).
- These nails will be less than 3 1/2" (90 mm) long.
- For a very wide range of nail sizes between 6d box to 30d common (0.099"-0.207, 3/32"-13/64", or 2.51-5.26 mm diameter)
|
| Drive NAIL HEADS.... |
- through forming and into supporting material
FIND THE RANGE OF HEAD DIAMETER THAT FITS, THEN SELECT THE TOOL BELOW IT:
- heads < 5/16" diameter (0.312" or 7.92 mm)
- heads >= 5/16" diameter (0.312" or 7.92 mm)
|
| To use the SAME denailer for the HEADS & THE POINTS of different nails.... |
- For a very wide range of nail sizes between 6d box to 30d common (0.099"-0.207, 3/32"-13/64", or 2.51-5.26 mm diameter) AND occasionally drive heads <= 1/4" diameter (0.250" or 6.35 mm)
- all nails are 16d box nails or smaller (0.148", 9/64" or 3.76 mm in diameter) AND occasionally drive or set finish nails.
|
|
Still have questions? Call 303-554-8557 or email admin@reconnx.com
|
